Tc-electronic Blacksmith Manual de usuario descargar pdf (Pagina 21)

APPENDIX – MISCELLANEOUS

Heat Protection Mode

Ifthedisplayindicatesan“H”,theampistoohot.Thisisrarely

seen, but a few extreme situations can invoke this mode:

a) If the amplifier is used in an environment that is too hot, or if

proper ventilation is not ensured.

b) The Load Impedance switch on the amplifier’s back plate

must match the load of the connected cabinet configuration.

If the Load Impedance switch is set to 4 Ohm and the

amplifier is run at high levels over a long period of time with

a 2 Ohm speaker configuration, the amplifier may enter Heat

Protection mode.

In both situations, proceed as follows:

– Turnofftheamplifier.

– Solvetheissues.

– Allowtheamplifiertocooloffforafewminutes.

– Turnontheamplifieragain.

Notice that due to Blacksmiths protection features the

amplifier will NOT be damaged if a wrong Load

Impedance setting is selected.

Protection mode

BLACKSMITH is equipped with an intelligent protection system,

ensuring that the amp does not suffer or malfunction if operated

wrongly or in extreme environments.

General Protection mode

IftheBLACKSMITH’sdisplayindicates“P”,theampisin

Protection mode.

Protection mode is invoked if for some reason a short-circuit

situation occurs. In Protection mode, the speaker outputs are

shut off so that the speakers cannot be damaged by a shortcut.

The balanced output, digital recording out and the effects loop,

however, are still passing audio in Protection mode.

To remedy the problem, try turning off your BLACKSMITH for

a minute and then turn it on again. If the display still indicates

“P”,youwillhavetosendyourBLACKSMITHtoaqualified

service-center for inspection.

1 2 ... 16 17 18 19 20 21 22 23 24

Sin comentarios

Tc-electronic Blacksmith Manual de usuario Pagina 21